START HERE
Replay a short local clip at a moderate level, then compare another output. Check whether the noise follows the recording, the device, or computer activity before changing audio settings.
1. Test a local audio file first
Choose a short passage where you can hear the fault, then replay it twice. Does the pop happen at exactly the same point, only during a loud section, or at unpredictable times? Try another recording in the same app. This creates a useful distinction between a damaged source, level-related distortion, and intermittent playback trouble.
Use a local file for the first comparison if one is available—you can check a WAV recording for near-full-scale peaks in the local WAV inspector, or play a clean reference sine tone or sweep from the online tone generator at low volume. A streaming service introduces another variable: interruptions might belong to the stream rather than the computer's output. Lower the volume before reconnecting equipment; a startup click should not be your loudest test signal.
2. Compare USB, wired, and Bluetooth outputs
Play the same passage through a second output without changing the app. Laptop speakers, a wired headset, and a USB device give different comparison points. If only one device crackles, check its cable, connector, power, and controls. If the noise follows that device to another computer, focus on the device rather than Windows.
For a USB headset or interface, compare a direct computer port with the dock or hub. For Bluetooth, compare a wired output if available. A Bluetooth-only problem deserves its own connection test; it does not establish that every Windows output needs a driver replacement.
3. Turn off Windows Audio enhancements & EQ
- In Settings → System → Sound, open the affected output.
- Note the existing Audio enhancements setting. If the device exposes it, switch enhancements off and replay the passage.
- Restore the original setting if the comparison makes no difference.
Also consider a recently changed equalizer preset in the app or device utility. Compare with its neutral preset. If a large bass boost is the change that brings the distortion back, you have a useful cause-and-effect result rather than a reason to keep raising the master volume.
4. Check sample rate and CPU workload
Microsoft includes trying another supported output format in its crackling-audio checklist. Under Output settings → Format in Windows 11 Sound settings (or Properties → Advanced in the classic Sound Control Panel), note the current format and select another offered option for a controlled test. Do not assume the largest sample-rate number is a repair. Restore the earlier value if the result is unchanged.
Close a busy game, export, or recording session and replay the baseline clip. If the fault disappears, add those activities back one at a time. For an audio interface used by recording software, use its own documentation when adjusting buffer settings; a buffer intended for minimal monitoring delay may not be the stable choice for that workload.
5. Update the exact audio driver
If the problem survives the comparisons, follow the manufacturer's driver guidance for the exact PC or audio device. Record the connection, driver version, affected apps, and whether the noise tracks computer activity. Those details make a support report actionable.
Once playback is clean, restore your normal app and volume and repeat the original passage. If the real issue is that sound becomes narrow or muffled when a call begins, use the Bluetooth microphone-mode guide; that is a different symptom from random clicks.
Sources & version notes
Platform steps were checked against the official documentation below on November 13, 2026. Labels and available controls vary by operating-system version and device. Manufacturer examples apply to the named models; consult your own device manual for its options.